Search results for "Electronic stability control"
showing 3 items of 3 documents
Optimization of vehicle-trailer connection systems
2016
The three main requirements of a vehicle-trailer connection system are: en route stability, over- or under-steering restraint, minimum off-tracking along curved path. Linking the two units by four-bar trapeziums, wider stability margins may be attained in comparison with the conventional pintle-hitch for both instability types, divergent or oscillating. The stability maps are traced applying the Hurwitz method or the direct analysis of the characteristic equation at the instability threshold. Several types of four-bar linkages may be quickly tested, with the drawbars converging towards the trailer or the towing unit. The latter configuration appears preferable in terms of self-stability and…
Three-mode pneumatic management of marine U-tank systems
2012
Abstract This paper deals with a new pneumatic control strategy for the roll damping enhancement of marine U-tank stabilizers. The proposed technique consists in a three-mode operation, where the control is active only within a limited resonant range around the ship natural frequency, whereas the control valves are kept closed in the remaining frequency range. Moreover the connection valve between the two air chambers is either closed or partially opened for the low or high frequencies, respectively. The pressurized air for the active control is fed by a turbo-blower set aboard and operates accelerating the motion of the water mass in the U-duct. The theoretical analysis is conducted in the…
Motion Control of Four-Wheel Independently Actuated Electric Ground Vehicles considering Tire Force Saturations
2013
A vehicle stability control approach for four-wheel independently actuated (FWIA) electric vehicles is presented. The proposed control method consists of a higher-level controller and a lower-level controller. An adaptive control-based higher-level controller is designed to yield the vehicle virtual control efforts to track the desired vehicle motions due to the possible modeling inaccuracies and parametric uncertainties. The lower-level controller considering tire force saturation is given to allocate the required control efforts to the four in-wheel motors for providing the desired tire forces. An analytic method is given to distribute the high-level control efforts, without using the num…